PPSU is an ultra-performance 3D printer filament that can be used to 3D print parts for demanding applications that are chemical resistant and can operate in temperatures up to 180°C.
Key features
- Solvay PPSU inside
- Excellent thermal properties with a glass transition temperature of 220°C.
- Flame retardant (UL 94 V-0) with low smoke evolution and low smoke toxicity
- Superior hydrolytic resistance
- Qualified for repeated steam sterilization (>1000 cycles)
- High Environmental Stress Crack Resistance (ESCR)
- Very high impact strength and high stiffness over a wide temperature range
- Very good resistance against high energy radiation (gamma- and X-rays)
- Good electrical insulating and dielectric properties
Applications
- Industrial applications
- Electronics
- Medical parts
- Aerospace applications
- Automotive
General printing guidelines *
Nozzle size: ≥ 0.4mm | Layer height: ≥ 0.10mm | Experience level: Expert |
Print temp: ± 360 – 400° C | Fan speed: 0 – 25% | Drying: +4 hours at max.110°C |
Heat bed: ≥ 120° C | Enclosure needed: 90°C heated chamber |
Adhesion: EasyFix Nr. VII |
*) Above displayed settings are meant as guidance to find your optimal print settings. These ranges in settings should work for most printers, but please do feel free to experiment outside these parameters if you think it is suitable for your printer. There are a lot of different type of printers, hot-ends and printer offset that it is extremely difficult to give an overall one-size-fits-all setting.
Filament length
ρ: 1.29 g/cc | 0.2 Kg spool | 0.5 Kg spool | |||
Ø 1.75mm | ± 64m | ± 161m | |||
Ø 2.85mm | ± 24m | ± 61m |